Virtual outer diameter of base body:Diameter (mm) 80.00Diameter (mm) 80.00Diameter limit (mm) 44.87Cone angle () 29.49Resilience of flange (mm/N) 3.410909e-007Addition for plate resilience (mm/N) 1.699713e-007Resilience of screw (mm/N) 2.947595e-006Load factor for centric load introduction 0.0538Amount of embedding (mm) 0.0080Preload loss (N) 2432.58required assembly preload:-minimum (N) 26994.12-maximum (N) 48589.41Pretension force according table (N) 65000.00Screw force at yield point (N) 79000.00attained assembly preload:-maximum (N) 64904.29(utilization of yield strength (%) 90.00)Pretension force (N) 62471.71Additional bolt load (N) 1338.47Additional plate load (N) 23561.53Fatigue load (N/mm) 7.94Fatigue life (N/mm) 48.88Number of load cycles >= 2000000 Nut standard Own InputInner diameter nut support (mm) 12.00Outer diameter nut support (mm) 25.00Thickness of nut (mm) 18.00Surface roughness (m) 16.00Material C45 (1)Shearing strength 460.00No washer below nut Through hole standard ISO 273:1979 (DIN 273) mediumDiameter through hole (mm) 13.50Chamfer at head (mm) 0.00Chamfer at nut (mm) 0.00 Load application factor 0.35Bolting type: SV 4Length of connected solid (mm) 0.00Distance of connected solid (mm) 3.89 Tightening technique: Own InputTightening factor 1.80Minim. Name : Bolts (VDI 2230, Example 1)Description: KISSsoft exampleChanged by: kspl on: at: 10:57:00īolt calculation according to VDI 2230:2014Ĭonfiguration: Bolted connection under axial load (single bolt)Calculation using assembly temperatureAssembly temperature (C) 20.00Thread standard Standard threadLabel M12Pitch (mm) 1.75Flank angle () 60.00Reference diameter (mm) 12.00Flank diameter (mm) 10.86Core diameter (mm) 9.85Nominal cross section of thread (mm) 113.10Core cross section of the thread (mm) 76.25Thread manufacturing Final heat treatedSurface roughness (m) 16.00Īxial force (N) 24900.00Required clamping force:For shearing force transmission (N) 1000.00For sealing (N) 0.00

Vdi 2230 part 2 pdf